Body clamping system

A common issue is holding down the body during a pull. Using velcro tape or other adhesives is often necessary to keep your body in place when pulling.

With the EZ-Pull 2 chassis, this is no longer an issue. The chassis has an integrated body clamping system. You can simply push on the body, and the clamps will clamp it down on the chassis.

On the side of the chassis, you find pushbuttons. Just push these to release the body when you need to do maintenance or swap batteries.

Driveline

Gearbox
The EZ-Pull 2 chassis features a unique gearbox concept that accepts both 10th and 8th scale brushless motors and nitro and gas engines.

By default, there are three different aluminum gear sizes available:

• 48T gear – for low RPM range.
• 60T gear – for medium RPM range.
• 80T gear – for high RPM range.

You can change gears within a matter of minutes. It is also possible to flip the gearbox 180 degrees in the chassis to allow the brushless motor to be mounted either in the front or rear position.

Rear axle
EZ-Pull uses a modified T-Maxx differential, with a CNC machined aluminum spool inside and a 6mm D-shaft. An aluminum CNC machine bracket holds the rear axle in place. On the sides, 3D printed axle supports with dual bearings ensure optimal support for the axle.

A steel heavy-duty universal joint connects the gearbox and rear axle with a 6mm D-shaft.

Electronics

The EZ-Pull 2 chassis comes with various options to place your electronics. By default, we mount a mini steering servo in the front of the chassis. But the front axle mounting blocks also accept a full-size servo if you wish to use one.

EZ-Pull includes a battery bracket with velcro straps. Depending on your motor setup, you can strap the battery on top or bottom of the bracket. Your ESC can go on top or the bottom as well, depending on where you located the battery.

Everything is nicely covered by 3D printed cover plates, which you can quickly remove to access the compartment for a quick battery change or other adjustments.

Hitch & rear section

The EZ-Pull 2 chassis comes with a 10mm thick aluminum hitch plate with two adjustment holes to bolt the hitch into. The hitch itself has a 0.6″ adjustment slot and can be flipped upside down, which will give you many adjustment possibilities.

The wheely bars are adjustable in height as well. Loosen up two 3mm bolts, and you can slide them up or down in the chassis.

Thanks to these adjustment options, you can use many different tire sizes, for example:

• Tamiya Clod Buster
• Proline Destroyer
• RC4WD Traxtor XL
• Or any other clod-sized tire.