Body clamping system

A common issue is holding down the body during a pull, often use of velcro tape or other adhesives are necessary to keep your body on place during a pull.

With the EZ-Pull chassis this is no longer an issue! The chassis has an integrated body clamping system. You can simply push on the body, and the clamps will simply clamp it down on the chassis.

On the side of the chassis you find push buttons, simply push these to release the body in case you need to do maintenance.

Driveline

Gearbox
The EZ-Pull chassis features a unique gearbox concept that accepts both 10th and 8th scale brushless motors, as well as any kind of nitro and/or gas engine.

By default, there are 3 different aluminum gear sizes available:

• 42T gear – for low RPM range.
• 60T gear – for medium RPM range.
• 80T gear – for high RPM range.

Gears can be changed within a matter of minutes. It is also possible to flip the gearbox 180 degrees in the chassis, this allows the brushless motor to be mounted either in front or rear position.

Rear axle
EZ-Pull uses a modified T-maxx differential, with a cnc machined aluminum spool inside and a 6mm D-shaft. The T-maxx axle is mounted in an aluminum bracket on the front and on the sides of the chasses are 3d printed trumpets with additional bearings to eliminate shaft flexing.

Gearbox and rear axle are connected with a 6mm D-shaft and a heavy-duty steel universal joint coupler.

Electronics

The EZ-Pull chassis comes with various options to place your electronics. By default a mini servo is mounted in the front of the chassis. But the front axle mounting blocks also accept a full size server in case you want to use one.

A battery bracket with straps is also included, depending on your motor setup you can strap the battery either on top or on the bottom of the bracket. Your ESC can go on top or the bottom as well depending where your battery is strapped in.

Everything is nicely covered by 3D printed cover plates, which can be easily removed to access the compartment for a quick battery change or other adjustments.

Hitch & rear section

The EZ-Pull chassis comes with a 10mm thick aluminum hitch plate, which has 2 adjustment holes where your hitch can be bolted into. The hitch itself has a 0.6″ adjustment slot as well and it can be flipped upside down. This will give you many adjustments possibilities so the hitch can be set at virtually any height.

The wheelybars can be adjusted in height as well, simply loosen up two 3mm bolts and you can slide it up or down in the chassis.

Thanks to these adjustment options you can use any tire size you want, whether they are clod busters, usa-1 or RC4WD tires. You can always adjust everything to get a perfect setup.